Aluminum alloy 595 x 595mm 40W square Emergency LED Panel Light IP44 100lm / w

Aluminum alloy 595 x 595mm 40W square Emergency LED Panel Light IP44 100lm / w

Product Specifications:

Description:

1. Bellaid flat LED panel light is a well- Designed for residential and 1. commercial conventional suspended grid ceilings for new construction applications or retrofitting existing fluorescent troffer light fixtures.widely used in offices,hospitals and other professional locales.
2. Huge savings can be achieved along with a significant reduction in maintenance costs making them perfect for use in Offices, Hospitals, Care Homes and Commercial installations.
3. It's equally just as good in your home - especially if you are unable to have recessed lighting installed.  Panel lighting is also being widely used by designers for Light Installations or Back Lighting.
4. This 595x595mm LED Panel light is designed to fit into a suspended ceiling with a 600x600mm grid dimension.  In this type of installation, the typical application for this LED Panel would be for it to replace a 600x600 trough of 4 x 600mm (2ft) T8/T5 Fluorescent tubes (refer to saving example below). 

Features

Save up to 60% energy usage compared to traditional fluorescent fittings.

Optional built in, surface and suspension mounting kits available.

Class II

High Lumen output

Long life of 40,000h

Slim profile design

Instant start

Negligible UV output

Mercury free

Photometric Information

                  4000K                                                                                           6000K  

Distribution curve flux:

 Illuminance demo:

User Guide Note:

Pls read the entire manual to fully understand and safe usely use this product.

The products anc be used at voltage of 100-277Vac,50/60Hz,suitable for indoor dry environment.

Specifications are subject to change without notice.pls visit www.LED-Panel-lights.com for the most recent user guide versions.

Unpacking

• Unpack and careful examine the product.
• Report any damage and save all packing material if any parts were damaged during transportation
• Do not attempt to use this apparatus if it is damaged.

Installation instructions

1)  Pls remove the protection film on the front of luminaire

• Consult a qualified electrician to ensure correct branch circuit conductor.
• The products should be installed and operated by qualified electrician or technician in accordance with relevant local codes.
• Rish of electric shock,ensure that main power source is off when wiring or soldering the sections of the product.

Maintenance

• Prior to cleaning the product,make sure it has been disconnected from power supply.
• Use a dry or slightly moistened cloth for cleaning
• Never use any chemical or abrasive materials for cleaning.

Installation considerations

• The product must be at a minimum distance of 20cm from any flammable material.
• The product must not be installed into ceilings or wall that contain heat-insulating materials.

Installation steps

• Built-in

• Turn off main power before wring.
• Remove the ceiling panel
• Connect the input and ground wires(bare end) of the driver box to the main power outlet.
• Connect male-female connector tightly on the panel and driver.
• Fix the flat led panel into the ceiling.

• Suspended (only applicable to 2*2 & 1*4 ft version)

Accessories for suspended installation are available at an extra charge

• Turn off the main power before wiring
• Fix the suspended box to the ceiling with screws
• Connect male-female connector tightly on the panel and driver
• Connect the input and ground wires(bare end) of the driver box to the main power outlet.
• Clamp the connectors of suspended cables to the interfaces of the panle light.